DCAM STORE: 2 ways using one stencil pattern and a card

Hello to all!

Happy Friday!

I am here with another inspiration Today!
Showcasing how to use the stencils to create 3D backgrounds!

Placed the stencil on a white CS as shown in the pic and added the DI ink.

Now flipped the stencil and placed it like as shown in the pic by overlapping design. Added another DI through the stencil, I created the design only the top left corner to the middle.

Here is the complete design.

Now fussy cut a lot of different Persian motifs with a bird on it. I chose a navy blue color CS and using a Martha Stewart Scoring Board created those lines at the left side and adhered that panel with dimension.

Highlighted all those areas with my brush using DI for more textures and depth. Added some black enamel accent dots. Now some splatters.

Die cut a Hello word and placed a banner with the sentiment- You're beautiful, inside and out from Blooming Beauty critter sheet.

Celtic design using the same stencil

Here is the other one, only the experiment with another design using the same stencil.

I created a Celtic design in rainbow colors using 3D Flip over Dual cube builder stencil 2.

Here are the steps:

Placed the stencil on a white CS and applied various DI using finger dauber.

Now flipped the stencil and placed it as shown in the pic and inked again.

You will get this result.

You will get the diamond shape design space left in between, now cover that space. I covered up my design with masking tape and added the black soot ink as shown in the pic below.