Drawer Box

Hello everyone!!
Hope all of you are having a good time reading the awesome posts at our blog!
Today i am here to share a tutorial with all of you!
This is going to be a picture heavy post so sit back with your favorite drink and relax!

I've made this drawer box. How's it??

INSTRUCTIONS:

Step 1- MAIN BOX

Cut a piece of 12*6 1/4 piece of cardstock.
Score this at 3", 6", 9" as shown below.

Step 2- DRAWERS
Cut four squares of cardstock measuring 5 7/8" * 5 7/8"
Score these at 1 1/2" on all four sides

Cut the 1st score mark on two sides as shown below.
I like to taper and shorten the flaps a little before gluing - this is optional.

Glue each drawer together.

Step 3- DRAWER PLACEMENT

Lay your main box scored piece down flat and then align and glue the drawer to the very top edge of the left panel repeat the same for the bottom right panel.

P.s- the tricky part
Now position the other two drawers. Position one drawer to the panel adjacent to the left top drawer just below the top drawer. Position the remaining drawer to the panel adjacent to the right bottom drawer just above the bottom drawer. Once satisfied glue them and fold the panel to check if they are aligned properly.

Step 4- THE LID

Cut a 5"* 5" piece of cardstock and score it at 1" on all four sides , taper and shorten the flaps and glue together.

Now the base is ready. Decorate it as you please!

Hope all of you enjoy the tutorial! 
Thanks for stopping by!

Hugs
Anchal Sapra